AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Snap on ya212a mig welder parts10/31/2023 I noticed USAweld had some parts for this unit, and even a replacement gun. The twelve positon tap switch has screw terminals on all the wires for easy replacement. Half the electrical parts are on the shelf in my store room. Its a pretty bare bones machine with no PC boards, run-in, or burn back control, but its been working good for me. Maybe because its a Snap On people didn't really have any interest, it lingered on Craigs list for about a month. None of the millers I saw was below $1800 dollars, and the one linde 250 with bottle,and spool gun was sold in an hour for $500. Originally I was looking for a millermatic 250, or even a migmaster 250 on craigslist. He threw in a 40 ft #8 sjotw cord and some extra blue demon wire with it. I asked a little less than he was asking because the wire feed wouldn't work below #2 setting on the Heat potentiometer. Got good welds on both in about 2 minutes with. When I went to test it out I brought a 3/4" round and 1/2" thick plate, and a piece of 16 Ga. He said a spoolgun cost too much, and he couldn't figure out how to run it well without a door chart. Guy bought from owner cheap, wanted to do aluminum. Story was that it came from an autobody shop that had it for a long time (lots of primer spatter on it) got replaced by something with LED's and digital read-outs.
0 Comments
Read More
Leave a Reply. |